English –
17
8
FURTHER DETAILS
8.1 - Adding or removing devices
You can add or remove devices at any timee.
STOP input
Input that stops movement immediately, followed by a brief reverse of the manoeuvre.
You may connect devices with NC contacts to this input; multiple devices can be connected in series.
N.B.: when the NC contact opens, the automation stops and reverses its direction briefly.
STOP
89
10
11
12
89
10
11
12
89
10
11
12
STOP
89
10
11
12
89
10
11
12
89
10
11
12
Photocells
To add a pair of photocells, proceed as follows:
01.
Power up the receivers (RX) via terminals 8 - 9
02.
Connect the receiver’s NC contact in series with the NC contact already connected to control unit terminals 9 - 11.
If using two pairs of photocells, to prevent them interfering with each other, activate the synchronisation function described in the respective
user manual.
TX
1 2
RX
2
1
5
4
3
89
10
11
12
89
10
11
12
89
10
11
12
TX
1 2
RX
2
1
5
4
3
89
10
11
12
89
10
11
12
89
10
11
12
8.2 - Power for external devices
To power external devices (transponder badge reader, or backlighting for a keyswitch) connect the device
to the control unit as shown in the figure.
The power supply voltage is 24Vac -20% ÷ +30% with a maximum available current of 100mA.
24 Vac (30 Vac max)
0
89
10
11
12
8.3 - Total deletion of the receiver’s memory
To cancel all memorised transmitters or all data in the receiver’s memory, proceed as follows:
01.
02.
03.
04.
↕
RADIO KEY
RADIO LED
RADIO LED
RADIO KEY AND LED
RADIO KEY AND LED
8.4 - Diagnostics
Some devices are display messages to identify their status and faults.
8.4.1 - Control unit signals
The leds on the control unit issue signals to indicate their normal/faulty operation.
Table 10 lists the signals:
Summary of Contents for ROX1000
Page 2: ......
