Nice ROBO600, Instructions And Warnings For Installation

Page: 10 / 32

8
– English

m - Cut any excess rack off the end
06.
Slide the gate open and closed by hand to check that the rack is properly aligned with the pinion.
N.B.: make sure that there is a gap of 1-2 mm between the rack and pinion for the entire length of the gate
1÷2 mm
07. Vigorously tighten the nuts to fasten the gearmotor to the
foundation plate
08. Install the OPEN and CLOSE limit switch brackets: proceed in the same way for each limit switch
OPEN:
a - Slide the gate open by hand, stopping it 2/3 cm before the mechanical stop
b - Slide the limit switch bracket along the rack in the open direction until the limit switch trips (you will hear it click)
c - After you hear the ‘click’, move the bracket further forwards by 2 cm (minimum)
d - Secure the bracket to the rack with the provided grub screws

+2 cm
click!
2-3 cm