C.2 - Memorising ANOTHER TRANSMITTER (second, third, etc.)
MONO
UP
STOP
DOWN
NOTES AND WARNINGS
•The motor configured to operate in ONE-WAY mode can memorise up to 30 transmitters.
• To run procedure C.2.1, you must have a
new transmitter
to memorise and an
old
previously memorised transmitter. The two transmitters must have the “PRG”
and “ESC” buttons (like “ERA P” and “ERA W” transmitters).
•
To run procedure C.2.2 you must have a
new
transmitter to memorise, chosen from the “Nice Screen” catalogue , and an
old
previously memorised transmitter.
C.2.1 - To memorise the transmitter buttons in “Mode I” (“Standard mode”)
• Procedure C.2.1 memorise all the
new
transmitter’s buttons in “Mode I”, with the same configuration as the
old
transmitter (for details about “Mode I” see par. 4.6.1).
1
2
3
NEW
8
sec.
OLD
(x
3
)
On the OLD transmitter:
hold down the but-
ton and
release it after
8 sec-
onds
.
On the OLD transmitter:
press and release the but-
ton (
3 times
), provided the button is memorised.
3
end
NEW
(x
1
)
3
On the NEW transmitter:
press and
release the button (
1 time
);
count
3 movements (= transmitter memorised)
. If
the system makes 6 movements (= memory locked or
full, transmitter not memorised).
C.2.2 - To memorise the transmitter buttons in “Mode II” (“Custom mode”)
• Procedure C.2.2 memorise a single button on the
new
transmitter in Mode II; i.e. they associate with the button (chosen by the installer) one of the commands in the
motor’s “list of commands” (for details on “Mode II” see section 4.6.1).
• Procedures C.2.2 memorise a single button. Repeat this operation to memorise another button.
• When performing the procedure, you can cancel the programming at any time by holding down
■
and
▼
together for 4 seconds. Alternatively, do not press any keys
and wait 60 seconds for the motor to perform 6 movements.
1
2
3
NEW
8
sec.
...
...
OLD
5
sec.
4
On the NEW transmitter:
hold down the
but-
ton you want to memorise
;
release it after
8 sec-
onds
;
On the OLD transmitter:
hold down the
button and
release it after
5
seconds
;
count 4 movements.
3
continues
Select the desired
option and program
it as follows
OLD
(x
...
)
4 OPTIONS:
1 press
= Open > Stop > Close > Stop > ...
2 presses
= Open
3 presses
= Close
4 presses
= Stop
On the OLD transmitter:
press and release the button
the number of times
indicated in the option you have chosen;
3
4
end
7
sec.
?
n
NEW
5
sec.
...
...
3
after about 7 seconds, the motor performs a
number of
movements
equal to the number of
pulses entered.
On the NEW transmitter:
hold down
the
same button you pressed in Step 1
;
release it after
5
seconds
;
count
3 movements (= transmitter memo-
rised)
. If the system makes 6 movements (= mem-
ory locked or full, transmitter not memorised).
C
English –
28
Summary of Contents for NX SOL MA 1014 SH BD
Page 39: ...English 38 ...
