B.6 - Programming an INTERMEDIATE POSITION (position “H”)
MONO
NOTES AND WARNINGS
•
This procedure memorises an intermediate position (position “H”) between the Up (“0”) and Down (“1”) limit switch positions. When the automation is being used,
after giving the
intermediate position
command, the system will automatically stop the roller shutter at the programmed “H” position.
• Up to 30 “H” positions can be memorised if the motor is configured to operate in ONE-WAY mode, or up to 6 “H” positions if the motor is configured to operate in
TWO-WAY mode, in any desired position, provided that they are within the space delimited by the two limit switches. These positions can only be programmed after
the limit switch positions. Repeat this procedure for each position you wish to memorise.
• The first “H” position must be programmed using the buttons
▲
+
▼
,
on the transmitter used to run the procedure itself
. However, each subsequent position
“H” must be programmed using a button
on another non-memorised transmitter
.
• To change an existing “H” position, move the awning to the desired height and run this procedure; in
step 06
, however, press the button associated with the exist-
ing “H” position you are changing.
1
2
3
4
“
H
”
(x
1
)
PRG
2
=
5
sec
2
Move the roller shutter to
the desired “
H
” position.
Press and release
the button (
1 time
);
count 2 movements.
Hold down both buttons...
release them after
5 sec-
onds
;
count 2 movements.
4
5
6
...
Precisely ad-
justing the
“H” posi-
tion
“
H
”
=
5
sec
3
Select one of the following potions
and execute it:
• option A
– to memorise the
FIRST “H” position.
• option B
– to memorise a SUP-
PLEMENTARY “H” position.
Press the buttons until you reach the desired position.
Hold down the but-
ton and
release it after
5 sec-
onds
;
count 3 movements.
option –
A
6
end
option –
B
6
end
=
5
sec
4
=
5
sec
...
...
4
Hold down both but-
tons...
release them
after
5 sec-
onds
;
count 4 movements.
On ANOTHER transmitter,
which has NOT been memo-
rised:
hold down any button
you wish;
release it after
5 seconds
;
count 4 movements.
B
B.7 - Memorising ANOTHER TRANSMITTER (second, third, etc.)
MONO
NOTES AND WARNINGS
•The motor configured to operate in ONE-WAY mode can memorise up to 30 transmitters.
• To run procedure B.7.1, you must have a
new transmitter
to memorise and an
old
previously memorised transmitter. The two transmitters must have the “PRG”
and “ESC” buttons (like “ERA P” and “ERA W” transmitters).
•
To run procedure B.7.2 you must have a
new
transmitter to memorise, chosen from the “Nice Screen” catalogue , and an
old
previously memorised transmitter.
B.7.1 - To memorise the transmitter buttons in “Mode I” (“Standard mode”)
• Procedure B.7.1 memorise all the new transmitter’s buttons in “Mode I”, with the same configuration as the old transmitter (for details about “Mode I” see par. 4.6.1).
1
2
OLD
PRG
2
1
sec.
2
PRG
On the OLD transmitter:
hold down the
button and
count 2 movements;
wait
again...
count 2 more move-
ments;
release the button.
B
English –
20
Summary of Contents for NX SOL MA 1014 SH BD
Page 39: ...English 38 ...
