Installing the PSTN module
Make sure that the control unit is not powered and insert the plug-in
module to connect the telephone line (Fig. 4). Connect the control
unit to the telephone line (Fig. 5).
Configuration
Verify the country to obtain the automatic configuration of the dial
tones. Enable the telephone switchboard (if present) and enter the
number to access the external line (switchboard by-pass); modify the
number or rings after which the control unit replies.
Requesting information and sending commands via tele-
phone call
The control unit can be accessed by dialling the number of the PSTN
line connected to the control unit, from any telephone number, by
entering after the reply signal the User PIN code followed by #.
If the voice messages have been recorded correctly, the control unit
will reply with the following voice message:
System name > incoming call reply
If the voice messages have not been recorded,
wait for the acous-
tic signal.
Enter the indicated codes and wait for the reply: the control unit will
reply with the recorded voice messages or, if none are recorded, with
acoustic signals to confirm the reception of the command.
2
PSTN connection
Operations
Description
*
Ambient listening and speakerphone dialogue
0#
Verification of the control unit’s ON/OFF status (enabled/dis-
abled)
0*1#
Full enabling (confirmation reply with 3 beeps)
0*2#
Partial enabling (set for the user)
0*0#
Disabling (confirmation reply with 1 beep)
#
Interruption of alarm calls
11
4
5
Summary of Contents for MNCUC
Page 2: ......
