Nice MhouseKit WG2W, Instructions And Warnings For Installation And Use

Page: 29 / 148

English
English – 27
TABLE 19
Quick flashes Status Action
1 flash
1 second pause
1 flash
Error in Power&Free System wireless
devices At the beginning of the manoeuvre, the devices present check does not
match those learned. It is possible that there are battery-powered devices
with no charge or which are faulty. If the device is faulty, proceed with
replacement, and carry out the procedure for removal of the failed device
and subsequent learning of the new one (paragraph 10.3.4)
2 flashes
1 second pause
2 flashes
Triggering of a photocell At the start of the manoeuvre, one or more photocells are preventing
movement; check to see if there are any obstacles. During the move-
ment, if the obstacle is effectively present, no action is required
3 flashes
1 second pause
3 flashes
Action of the “motor force” limiting
device
During the movement, the gate experienced excessive friction; identify
the cause
4 flashes
1 second pause
4 flashes
Activation of the STOP input At the start of or during the manoeuvre, the STOP input was activated;
identify the cause
TABLE 18 (PH100W - FL100W)
RADIO LEDs Status Action
led LED B1 off
led LED B2 off
led LED B3 off The automation is in test phase or in stand
by; bad quality of radio signal received from
wireless device Insufficient radio communication; search for a better position for
the device
led LED B1 on
led LED B2 off
led LED B3 off The automation is in test phase; poor quality
of radio signal received from wireless device Limited radio communication; if possible, search for a better posi-
tion for the device
led LED B1 on
led LED B2 on
led LED B3 off The automation is in test phase; good qual-
ity of radio signal received from wireless
device Normal operation
led LED B1 on
led LED B2 on
led LED B3 off The automation is in test phase; optimum
quality of radio signal received from wireless
device Normal operation
led LED B1 off
led LED B2 one quick flash
every 2 seconds (
* )
led LED B3 on
Automation in movement and the solar pan-
el is charging the device batteries Normal operation
( *) these indicators are seen only during the wireless network test phase (see paragraph 8.2 – Wireless devices test)
B1 = MINIMUM signal level - B2 = MEDIUM signal level - B3 = MAXIMUM signal level
TABLE 20 (fig. 48)
LED [C] Status Action
Off Malfunction Make sure there is power supply; check to see if the fuses are
blown; if necessary, identify the reason for the failure and then
replace them with others of the same type
On Serious malfunction There is a serious malfunction; try switching off the control unit
for a few seconds; if the condition persists, it means there is a
malfunction and the circuit board has to be replaced
One flash every second All OK Normal operation of control unit
2 long flashes The status of the inputs has changed This is normal when there is a change in one of the inputs:
OPEN, STOP, triggering of photocells or the radio transmitter
is used
1 flash every 5 seconds Automation in “standby” mode All OK; when a command arrives, the control unit will reset to
normal functioning (after a brief delay)
Series of flashes separated by
a pause This is the same signal as on the flasher, see Table 19 .
STOP LED Status Action
Off * Activation of the STOP input Check the devices connected to the STOP input
On All OK STOP Input active
OPEN LED Status Action
Off All OK OPEN input not active
On OPEN input activation Normal only if the device connected to the OPEN input is active