Warning:
Follow all safety and installation instructions correctly to
avoid serious injury. Installation should be done by a professional.
Consult your dealer.
01 - INSTALLER RECOMMENDATIONS
• Install the equipment with the power switch off;
• For general automation protection, a circuit breaker must be used
according to motor specification;
• Keep remote controls out of the reach of children;
• Never touch electrical and electronic components with the power
switch on;
• Do not connect ground to GND;
• Do not leave anything resting on the power cord;
• Avoid exposing the power cord in crowded places;
• Do not overload outlets and extension cords as this may cause fire
or electric shock;
• Never spill liquid on the electronic control panel;
• Do not repair the electronic control panel, as you may be exposed
to dangerous voltage or other hazards;
• Take the product to be repaired to a qualified technical assistance;
• UNINTENDED EQUIPMENT MAINTENANCE MAY CAUSE SE-
RIOUS INJURY!
Read the entire manual before installing or operating this product.
Keep it in a safe and clean place for future reference.
Make sure that the outputs are not shorted. It is recommended that
you always tin the bare wire ends for best conductivity.
02 - AUTOMATIC CONTROLLER PREPARATION
1- Position the limit switches;
02.1 - ROCKER AUTOMATIC
63
ENGLISH
