Nice FILO 400, Simplified Instructions

Page: 16 / 36

6 – English
English
5
MEMORISING TRANSMITTERS OR THE KEYPAD IN MODE 2
Using this programming mode, you will programme a single button of the transmitter or keypad on this automation by associating one of the desired
commands listed in the table below.
Using this programming mode, you can programme all the buttons of
the transmitter or keypad on this automation with the following functions:
T1
: Open / Stop / Close function
T2 : Pedestrian Opening / Stop / Closing function
T3 : Opening / Stop function
T4
: Close / Stop function
T5 : light with ON / OFF function
Procedure for programming the transmitter:
01.
Press button P4 (on the control unit) for at least 3 seconds.
02. Release the button when LED L4 lights up.
03.
Within 10 seconds, press any button of the transmitter to be
memorised for at least 3 seconds: LED L4 must flash 3 times.
04.
Wait 10 seconds for the transmitter’s memorisation.
Procedure for programming the DS100 keypad:
01. Press button P4 for at least 3 seconds.
02. Release the button when LED L4 lights up.
03. Within 10 seconds, enter code 11 (or a new code) on the keypad
and press button B on the keypad for 4 seconds: LED A must flash
3 times.
04. Wait 10 seconds and the code’s keypad will be memorised
The code can be personalised by performing procedure 6, which can be
found in the keypad’s instructions.
5.1 - SELECTING THE COMMAND TO BE ASSOCIATED
WITH YOUR KEY
01. Press button P4 for a number of times corresponding to the chosen
command. LED P4 will flash a number of times equal to the desired
function.
02. Within 10 seconds, press the button of the transmitter you wish to
associate with this function for at least 3 seconds. LED L4 should
flash 3 times.
03. Wait 10 seconds and the transmitter will be memorised.
TABLE 2 - Command memorisation
Number of button presses Associated command
Number of flashes of LED L4 on the
control unit
once
Step-by-step 1
2 times Pedestrian opening 2
3 times Pedestrian 3
4 times Closing 4
5 times Light output (device) 230 V: ON-OFF 5
4
MEMORISING TRANSMITTERS OR THE KEYPAD IN MODE 1
LED
T5
T2
T4 T3
T1
A
B
C
20
Fuse 1.6A T
Flash
ECSbus
Stop
Aerial
SbS
OGI
Fuse 15A
P4
L4 L3 L2
P3 P2
SbS
L1
P1
Fuse 1.6A T
Flash
ECSbus
Stop
SbS
OGI
use
15A
L2
P2
SbS
L1
P1
Fu
L L3 3
P P3 3 3
P4
L4 L3
P3 P4
L4 L3
P3
3 s
21
Fuse 1.6A T
Flash
ECSbus
Stop
Aerial
SbS
OGI
Fuse 15A
P4
L4 L3 L2
P3 P2
SbS
L1
P1
Fuse 1.6A T
Flash
ECSbus
Stop
SbS
OGI
use
15A
L2
P2
SbS
L1
P1
Fu
L L3 3
P P3 3 3
P4
L4 L3
P3 P4
L4 L3
P3
22