English –
4
PROGRAMMING AND ADJUSTMENTS
4
4.1 - Groups of programming and adjustment pro-
cedures
There are 4 groups of programming and adjustment procedures:
Group A
– using the DMBM
module over the T4 BUS.
Procedures only possible using
the DMBM module over the Nice
T4 Bus.
Group B
– using the buttons
on the motor head.
Manual adjustment of the limit
switches, with precise, accurate
results.
Group C
– done with a dedi-
cated programmer.
Programming with a programmer
or other compatible accessory
(for instance: TTP).
Group D
– using a smart-
phone.
Programming with a smartphone
with NFC (Near Field Commu-
nication). This technology is not
yet available on this motor.
4.2 - Positions in which the awning stops automati-
cally
The electronic system that controls the awning movement at all times can automati-
cally stop the motor when the awning reaches a certain position (or “height”) pro-
grammed by the installer. The positions are shown in
fig. 5
as follows:
– position “0” = UP limit:
(awning completely retracted);
– position “1” = DOWN limit:
(awning completely extended);
– position “H” = INTERMEDIATE position:
(awning partially open)
4.3 - General warnings
• The limit switch must be adjusted after installing the motor in the awning and con-
necting it to the power supply.
• Comply strictly with the time limits indicated in the procedures: after releasing a key,
you have 60 seconds to press the next key indicated in the procedure; otherwise,
when the time is up, the motor will perform 6 movements to communicate cancel-
lation of the procedure in progress.
• During Group "B" procedures, the motor performs a certain number of
brief move-
ments
, as a “response” to the command sent by the installer. Count these move-
ments regardless of their direction. The movements are indicated in the procedures
with a number followed by the symbol
.
5
UE declaration of conformity
Note
: This declaration corresponds to the official declaration held at the
registered offices of Nice S.p.a., and in particular to the latest revision
available at the time of printing of this manual. The text herein has been
adapted for editorial purposes. A copy of the original declaration may be
requested from Nice S.p.a. (TV) I.
Declaration number:
544/Era INN Smart-AC
Revision:
2
Language:
EN
Name of manufacturer:
NICE S.p.A.
Address:
Via Pezza Alta N°13,
31046 Rustignè di Oderzo (TV) Italy
Person authorised to compile the technical documentation:
NICE S.p.A.
Type of product:
Tubular gearmotor for indoor vertical blinds and
darkness blinds
Model / Type:
E SMART SI 332 AC, E SMART SI 620 AC,
E SMART SI 1012 AC, E SMART MI 332 AC, E SMART MI 632 AC,
E SMART MI 1020 AC
Accessories:
-
The undersigned, Roberto Griffa, in the role of Chief Executive Officer,
declares under his sole responsibility, that the product specified above
conforms to the provisions of the following directives:
• DIRECTIVE 2014/35/EU (LVD):
- EN 60335-1:2012+A11:2014
- EN 60335-2-97:2006+A11:2008+A2:2010+A12:2015
- EN 62233:2008
• Directive 2014/30/EU (EMC)
- EN 55014-1:2006+A1:2009+A2:2011
- EN 55014-2:2015
- EN 61000-3-2:2014
- EN 61000-3-3:2013
Oderzo,
12/07/2017
Ing.
Roberto Griffa
(
Chief Executive Officer)
