11
Install harness
cable here
Terminal block for
motor connections
Install the harness to the motor as shown. Connections will be
made to the terminal block on top of the motor assembly.
1
2
3
4
5
1
2
3
Connect the harness limit and sensor wiring to the 5-pin
connector as shown below. These connections enable the
limit switch and smart sensor inputs into the gate controller.
Connect the harness motor leads to the 3-pin connector
as shown below.
Note: If the gate moves in the opposite
direction from what is expected, reverse the motor wiring
from what is shown. (Red to Pin 3, Black to Pin 1).
Limit and
Encoder wiring
Motor wiring
green
yellow
blue
orange
white
red
black
green: limit common
yellow: motor encoder signal
blue: common
orange: open limit switch
white: close limit switch
12 - MOTOR WIRING
Mount the control box within 4 feet of the motor assembly.
Do not mount the control box where the person using the
push button on the side of the box can come in contact with
the gate. Use mounting hardware capable of supporting the
weight of the control box with the backup battery included.
11 - CONTROL BOX MOUNTING
Install the 5 and 3-pin connector for motor 1 into the
connection labeled “Motor 1” on the controller as shown.
For a dual gate installation install the 5 and 3-pin and
connector for motor 2 into the connection labeled “Motor 2”.
Note:
(Motor 1) - Make sure motor lead connector is plugged
in below the limit 5 pin terminal connector
MOTOR 2
MOTOR 1
13 - LIMIT AND MOTOR CONNECTION TO THE BOARD
orange
gr
een
white
yellow
blue
black
re
d
Summary of Contents for H12-ETL-1K
Page 2: ......
Page 27: ...27 1 1 2 2 A A B B COMPANY NICE APOLLO NAME CONTROL BOX GENERAL OVERVIEW 18 22 18 18 8 32...
Page 30: ...30...
