2-24
|
ni.com
Chapter 2
Installation and Configuration
Removable Hard Drive
This section provides information on the installation and removal of the removable hard drive.
Caution
The removable hard drive must be installed before powering on the
NI PXIe-8135 and should not be removed during operation.
Installing the Removable Hard Drive
To install the removable hard drive, complete the following steps:
1.
Hold the removable hard drive so that the top side is facing right, as shown in Figure 2-6.
2.
Insert the removable hard drive so that it is completely seated in its connector. The insertion
resistance will increase for the final connector mate.
3.
If the removable hard drive does not easily insert, do
not
force the drive. Check the
alignment and try again. The removable hard drive may not be flush with the front of the
NI PXIe-8135 when fully inserted.
4.
Tighten the thumb screws. If the thumb screws do not thread, the removable hard drive may
not be fully inserted. Try removing and completely inserting the removable hard drive.
Figure 2-6.
Installing the Removable Hard Drive in an NI PXIe-8135 Controller
1
Removable Hard Drive
2
Thumb Screws (2x)
1
2
2
