©
National Instruments Corporation
5
NI CB-2162 User Guide
Installing Cables
A cable connects the NI CB-2162 to the digital waveform
generator/analyzer. Figure 2 shows how to install a cable.
Figure 2.
Connecting a 68-Pin Digital Waveform Generator/Analyzer to the CB-2162
Refer to Figure 2 as you complete the following steps to install the
supported cable:
Caution
Before
connecting the cable, disconnect power from the module, accessory, and
any other connected hardware to prevent damage to the hardware and personal injury. NI is
not
liable for damage resulting from improper connections.
1.
Install NI-HSDIO or NI-DAQmx and the digital waveform
generator/analyzer by following the installation procedure in the
Getting Started Guide that shipped with your device.
1
PXI Chassis with NI Digital Waveform
Generator/Analyzer
2
Cable
3
NI CB-2162 Accessory
NI PXIe-6536
25 MHz Digital I/O
DIGIT
A
L D
A
T
A
& CONTR
OL
ACCESS
ACTIVE
NI PXI-1042
3
2
J15
J3
J4
4/DDC
CLKOUT
5/
STROBE
F6 F5 F4 F3 F2 F1
1
