Nexxt NPC-F12U64B, User Manual

Page: 5 / 9

4. Repeat instructions 1 though 3 to attach the right support frame
to the bottom panel.
Note: do not fully-tighten the screws at this point.
5. Once step 4 is executed, your bottom panel subassembly will be
ready for next phase.
2
15
Frame subassembly
1. Place and align the top panel onto the bottom panel subassembly.
The section with the grille must be facing the front, and the cable
entry plate should be facing the back.
2.Secure both ends of the frame to the top panel using the M8x12
hexagon screws and nuts, as shown in the image below.
Bottom panel subassembly
Top cover with fan assembly
M8x12 hexagon screws (8)
14
1
5. The frame assembly has been successfully completed.
4. Attach the cable entry plate to the fan assembly tray using the
M4x8mm self-tapping screws.
3. Insert the M4 self-tapping screws onto the front end of the
bottom panel subassembly, as shown in image below.
Note: now that the frame assembly is complete, firmly tighten all the
screws to properly secure, align and square off the structure.
M8 flange nuts (8)
M4x8mm self-tapping screws (6)
18
FRONT
Cable entry plate (2)
13