Nexus Wind Data, Installation And Operation Manual

Page: 7 / 79

6
1 Installation
You can install the Nexus Wind Data in three different ways:
• The wind transducer is connected directly to the Nexus Wind Data
instrument
• By using the connection kit when both log and wind transducers are
installed with a single Wind Data.
• The installation may also include a Nexus Server where all transducers
may be connected. All data including power will pass along one cable.
• The installation includes 6 major steps:
1. Read the installation and operation manual.
2. Plan where to install the transducers and instruments.
3. Run the cables.
4. Install the transducers and instruments.
5. Take a break and admire your installation.
6. Learn the functions and calibrate your system.
Before you begin drilling ... think about how you can make the installation
as neat and simple as your boat will allow. Plan where to position the
transducers, Server and instruments. Think about leaving space for
additional instruments in the future.
•
A few ”do nots” you should consider:
−
Do not cut the cables too short. Allow extra cable length at the Server so
it can be disconnected for inspection without having to disconnect all
attached cables.
−
Do not place sealant behind the display. The instrument gasket
eliminates the need for sealant.
−
Do not run cables in the bilge, where water can appear.
−
Do not run cables close to fluorescent light sources, engine or radio
transmitting equipment to avoid electrical disturbances.
−
Do not rush, take your time. A neat installation is easy to do.
•
The following material is needed:
Wire cutters and strippers.
Small and large Philips and small flat head screw driver.
Hole saw for the instrument clearance hole 63 mm (2½").
2.8 mm (
7
/
64
") drill for the mounting holes in wood.
3.2 mm (
1
/
8
") drill for the mounting holes in fibre glass.
Plastic cable ties
If you are doubtful about the installation, obtain the services of an
experienced technician.
The warranty is not valid if you have damaged the instrument by
drilling through the front mounting holes.
2: INSTALLATION