27
7.3 Nexus Network error messages with cause and remedy
If an error message [Err #] is displayed, an error has been detected by the Nexus Network.
The message can assist you to diagnose the cause and remedy the error.
To escape from an error message, press any push-button. If not possible to escape, reset
power (turn off and on again), then make the remedy if suggested below.
Note!
For errors marked with [*], contact your national distributor to return the unit for
rectification.
No.
Message and cause
Remedy
*
01
Activated watchdog timeout.
Reset power.
*
02
Nexus Network data frames are missing.
Check connections and setup.
03
No data received within approx. 10 sec.
Check connections.
04
EEPROM read.
Reset power.
*
05
EEPROM write.
Reset power.
*
06
RAM memory error.
Reset power.
*
07
Auto-log full, in GPS Compass.
Clear Auto-log memory.
08
Break reset.
Reset power.
*
09
EEPROM auto initiation, or NMEA
transmit fail. (Nexus Server only).
Reset power.
*
10
Range error, depending on wrong input
e.g. 17
°
70' = too many minutes.
Correct input format..
11
Remote control setup error. Command
can not be executed.
Check connections and settings.
12
No response from navigator.
Check navigator connection and set-
tings.
13
Waypoint not defined.
Define a waypoint.
14
Impossible command when used with an
external NMEA navigator.
Use only possible command.
15
Impossible command when in Autopilot
mode.
Use only possible commands.
16
Auto-deviation is not possible.
Check for extreme magnetic field, up-
side down mounting of transducer or
wrong transducer type setting.
17
Auto-deviation check failed.
1¼ turn not completed or extreme
magnetic disturbance.
18
Auto-deviation. Function denied.
Function denied since compass is
busy with the auto-deviation routine.
19
Auto-deviation failure.
Error larger than 1.5
°
. The boat
probably hit a wave during the turn.
20
GPS to CPU communication error.
Reset power.
*
21
GPS acquisition failure (time out).
Maximum allowed time for searching
satellites. E.g. when try to navigate
indoors. Check GPS antenna loca-
tion.
22
CPU to GPS communication error.
Reset power.
*
23
DGPS (RTCM) data ignored.
Change the DGPS (RTCM) setting.
24
GPS bad fix, no fix position (time expired
at one-fix).
Check GPS antenna location.
7 FAULT FINDING
FAULT FINDING
