27
Temperature Sensor Wiring Diagram
Installation of Automatic Drive ID and Temperature Sensor on one mobile unit
When installing more than one 1-Wire device on the same VT-2300, follow the wiring diagram below
for correct connections.
NOTE: If the installation is to include both the Temperature Sensor and Automatic Driver ID, connect
the red and black Extension Adapter Cable to the green (PIN1) and black (PIN6) wires from the 6-pin
Adapter Cable.
Then splice the raw end of the Extension Adapter Cable to the Temperature Sensing Probe and the
iButton Reader as follows:
a) Splice the blue (Temperature Sensor), red (iButton Reader), and red (Extension Adapter Cable) wires
together using electrical splice connectors, such as Scotch locks.
b) Splice the brown (Temperature Sensor), black (iButton Reader), and black (Extension Adapter
Cable) wires using electrical splice connectors.