NextBase 302G Deluxe, Instruction Manual

Page: 27 / 32

The iN-CAR CAM can not lock
onto satellite.
Video Image is blurred.
Video recording is jumpy or
freezes.
Video has no sound.
Photograph is blurred.
I can only record a few minutes
of video on my SD card.
Mass Storage or PC Camera
function does not work.
The sucker will not stay in
place upon my windscreen.
The AV Out from my iN-CAR CAM
just buzzes on my TV.
I get the message “SD Card Error”
on screen.
I get the message “Memory error”
on screen.
I get the message “SD Card Full”
on screen.
With the IR LED's turned on, they
do not seem to enable night time
recording at a distance, in zero
light conditions.
My iN-CAR CAM shuts down by
itself after a while.
No power to my iN-CAR CAM,
but it works upon my PC.
After power on and with the device mounted with clear view of
the sky it can take up to 10 minutes to find the three satellites
required to achieve a stable signal. Reception can also be
affected by atmospheric conditions and the proximity of
buildings / trees obscuring the sky, heated or reflective
windscreens.
Turn iN-CAR CAM off and on to restart GPS search procedure.
Remove the protective lens cover, clean the lens, clean the
windscreen inside and out.
Remove the SD card and reformat to remove non-contiguous
files. For best recording use a branded class 10 type (30MB/)
SD card of 8 to 32GB recommended size. Playback PC may
not be sufficient for the playback software, try an alternative PC.
Ensure that “Record Audio” setting is turned ON within the
Video Menu.
Hold the camera still whilst taking the photo. Please be aware
the photo is taken around 1 second after the shutter noise is
heard.
Change the recording size (Loop recording function) to a
smaller size. Increase the size of the SD card. Max 32GB.
Will only work with Windows PC's. Restart the PC, as this may
be required for the necessary driver to be loaded correctly.
Disconnect and reconnect the In-CAR CAM.
Contact NEXTBASE for the required driver.
Ensure that the protective cover (plastic film) has been removed
from the suction pad.
Ensure that the rotary dial is fully counter clockwise. Make sure
that the glass is smooth and clean. Do not stick to glass that
has any non-smooth effect or paint whatsoever. Affix to the
glass firmly and then rotate the dial clockwise, until the latch is
felt to engage.
Ensure that the AV cable is correct. Use a stereo 3.5mm jack
plug where the tip is the video and the ring is the audio signal.
The SD card has become unuseable by the iN-CAR CAM.
Remove useful files using your PC and then perform a
“FORMAT” upon the SD card from within the SETUP menu.
The SD card has become unuseable by the iN-CAR CAM.
Remove useful files using your PC and then perform a
“FORMAT” upon the SD card from within the SETUP menu.
The SD card has become full as the Loop recording function is
set to OFF. Set the “Loop Recording” function to 3mins (default)
to enable the cycle recording function and automatic deletion of
older files.
Normal. The IR LED's are intended for short range use only.
For night time recording the vehicle headlights provide the
illumination of the road ahead.
Either the battery has gone flat, or there is no power to the
iN-CAR CAM and the AutoPower Off period (which is in the
SETUP menu) has been triggered.
The cigarette power cable is not working. Inspect the fuse in the
Car Power plug. Replacement fuse = 2A 20mm type. If the fuse
if found to be blown, inspect the power cable for damage which
may have caused the fuse blow.
27
PROBLEM SOLUTION
TROUBLE SHOOTING