June 2020
Shark SD110/SD120 | 22
There is no requirement to run VCarve on the same computer as you use in the shop to connect
to the Shark SD110/SD120 Controller Interface.
Installing the Shark SD110/SD120 Post Processors in Vectric Products
Vectric’s
VCarve, Vcarve and Aspire should have
Next Wave CNC (*tap
). post processors
installed. However, Next Wave CNC periodically updates these, and you may want to install the
latest
Next Wave CNC (*tap
) post processors. Additionally, older Vectric products may not
have the
Next Wave CNC (*tap
). post processors installed.
Currently, there are 2 sets of post processor files:
•
One set is used with VCarve, Cut 3D, and Aspire -
Next Wave CNC (*tap
).
•
One set is unique and used only with Photo VCarve
You can update the post processor used by any Vectric product by downloading the latest
version from the NextWaveCNC.com d
ownloads page and copying it to the Vectric product’s
post processor folder. The folder locations for each Vectric application are discussed below. In
no case should you attempt to download the post processor file directly from the Downloads
page to the final destination folder. You should copy the post processor file(s) to a known
location
–
typically somewhere in /My Documents
–
and then copy that file to its final
destination.
FOR THE MOST RECENT MANUALS, DRIVERS, AND OTHER SOFTWARE, PLEASE VISIT THE
DOWNLOAD TAB AT
