Installation instructions for the BANC D.sign above water automatic slatted safety cover - 8/24
8
3.1.3 Fig. 14
Unscrew the 3 M5 x 12 countersunk head screws on
the top of the side guard. Remove the two plastic
rivets on the sides of the side guard by unscrewing
them using a cross-tipped screwdriver. Then remove
the guard and repeat the operation at the other end
of the bench.
Fig. 14
3.1.4 Place the bench directly on the levelling course. The
upper surface of the casing must be perfectly level.
Fig. 15
3.1.5 Carry out rolling and unrolling tests to optimise
the bench position. At most, the bench can be
advanced by 150 mm compared to the rear coping
edge overhang or the end of a possible radius.
3.1.6 Only fix to the ground after having carried out all the
adjustments and checks, and advance the bench
onto the pool, if necessary, to avoid any rubbing of
the slats on the coping or the back deck.
Ø 580
150
30
Fig. 15
3. Roller shaft Installation
3.1 Upper casing removal
Place the bench directly on the levelling course. For
zones on coping, make sure the top of the coping
is less than 12 cm from the water level to maintain
compliance.
3.1.1 Fig.12A and 12B
To remove the duckboards, just lift them.
Fig. 12A
Fig. 12B
For a deckchair, see removal in section 7.2.
3.1.2 Fig. 13 (For a bench fitted with one)
To remove the top casing panel, unscrew the 4
M5 x 12 cylinder head base nuts and
remove the panel.
1
2
Fig. 13
