HOW TO INSTALL
HOW TO INSTALL
21
20
E.
Fully lengthen lap or lap sash seat belt and insert
in through near seatbelt slot in the seat back.
Ensure the seatbelt is between the harness
straps at the back of the restraint and the
vehicle seat. From the back of the restraint, push
seatbelt out through the far seatbelt slot to the
front of the seat.
F.
Engage seat belt buckle and tongue ensuring that lap part
of seat belt is within the recessed area. Push down on the
restraint and adjust the seat belt to hold the restraint firmly
against the vehicle seat by pulling on sash strap to remove
slack in lap strap. Pass the sash belt between the side of the
headrest and the side of the seat. For retractor seat belts,
allow excess belt to feed back into retractor.
NOTE:
Some vehicle seats have more rearward slope than others. Use a rolled up towel or padding under the
seat for contoured vehicle seats to prevent excessive recline.
Upper
Anchorage
strap
Sash belt
Seat belt
on the
outside of
the harness
straps
Lap belt
Sash belt
Near Seat
belt Slot
Yellow marker identifies
FORWARD FACING
BELT PATH
Far Seat
belt Slot
G.
Fully press Upper Anchorage Strap Adjuster
Button (1) while pulling Upper Anchorage
Strap (2) to slacken as shown right.
H.
Fit the Attachment Clip to the Anchor Fitting
making sure to remove as many twists as
possible. Pull Upper Anchorage Adjustment
Strap (3) to remove slack.
ALWAYS
roll up excess strap tightly and neatly
store away from child’s reach using the storage
band.
IMPORTANT:
Always ensure that the car seat belt and upper anchorage
strap are firmly restraining the restraint on the vehicle seat.
Always attach hook and remove slack.
Attachment Clip and Cover
3
2
Pull Adjustment
Strap to remove
slack
Storage
Band
1
Car's Anchor Fitting
Roll up excess
strap tightly so the
webbing is thick
enough to be held in
the storage band.
TODDLER USE: WITH IN-BUILT HARNESS
TODDLER USE: WITH IN-BUILT HARNESS
Summary of Contents for 10/D/2010
Page 34: ...66 NOTES 67 NOTES...
