®
50
5
not touch or tamper with the
electronics.
TROUBLESHOOTING
In addition to the tips given below,
a thorough list of troubleshooting tips is
at
bbFAQ.nextadvance.com
start,
make sure the Power Switch is in
the ON (I) position. Make sure that the
position. The plug of the power supply
cord might not be in a live wall outlet
or the power supply connector might
not be fully inserted in the AC Input
Receptacle of the Bullet Blender 50.
If the unit stops working,
turn the
system off for 15 minutes to allow the
electronics to reset. If the Bullet
Blender 50 does not turn on after this
period, contact customer service.
If the caps on the 50 mL tubes
loosen,
make sure that the screw
threads between the lids and the caps
are dry when you close the caps or
screw them on, so that there is enough
friction for the caps to remain tight.
Using recommended types of tubes will
minimize cap failure.
For best results, the tubes and
sleeves should be evenly spaced when
placed in the Bullet Blender.
If the 4°C light is not coming on,
frost from condensation may be
blocking the air passage. Remove the
inner dry ice compartment and gently
agitate it or replace the ice. If mist
coming out of the dry ice cooling
container seems excessive, make sure
that the lid of the dry ice container is
closed securely.
SUPPORT
FAQs, protocols, and other helpful
information are available on our
website,
Click
on the Bullet Blender, then on the
appropriate link. If you cannot find an
answer there, please contact customer
service by email at
[email protected] or by
telephone at (518) 674-3510 or (800)
738-1681.
SPECIFICATIONS
Size: BB50-DX is 35 cm (14 in.) deep x
38 cm (15 in.) wide x 38 cm (15 in.)
high.
BB5050-AU is 35 cm (14 in.) deep x 46
cm (18 in.) wide x 38 cm (15 in.) high.
Weight: 33lbs (15 kg)
Power Requirement: 100-240 V, 50-60
Hz, 2.5-4.5 A
Capacity: 8 of 50 mL skirted (self-
standing) polypropylene tubes.
Relative Humidity: 5 - 90% non-
condensing
Operating Temperature: 4 - 40°C
Altitude: <2000m
Storage Temperature: -40 to 50°C
Meets
requirements (-CE
models only)
DOMINIQUE DUTSCHER SAS
