5. Tightly bolt the front of the Nexsan E32X/Nexsan E18X to the mounting spacers (if installed) or rack
face.
Figure 3-9: Bolting the enclosure in place
Restore the power supply units
CAUTION
: Computer components and disk drives are sensitive to electrostatic discharge (ESD).
Always ground any electrostatic charge from your person before touching components with your
hands or with any tools. Always use an anti-static wrist strap (one ships with each Nexsan Storage
System) while installing or performing maintenance on any Nexsan Storage System. See
on page 24 for detailed instructions.
►
To insert the two PSUs into the back of the Nexsan Storage System:
1. Make sure that the PSU is right side up. The spring lock tab should be at the top (see "Rear panel"
)).
2. Insert the PSU into the slot and carefully slide it back until the spring lock tab clicks into place.
Figure 3-10: Sliding the PSU into place
3. Repeat steps 1 and 2 for the second PSU.
Note
Do not connect the power cords to the PSUs at this time.
Restore the power supply units
32
Part Number: P0450138, Rev. B
Nexsan BEAST™ and E-Series™
3