Nexo GEO S12 EN54 Series, System Manual

Page: 23 / 53

GEO S12 EN54 HARDWARE SETUP PROCEDURE
System Manual GEOS12 EN54
Page 23 / 53
7.3.2 Single GEO S12 EN54 rigidly mounted on a wall or a ceiling (vertical or horizontal)
Required items
- 1 x VNI-UBRK12 (allows all angles to be implemented)
- 4 x 12mm diameter screws ( not provided )
IMPORTANT
Ensure that the surface
– wall or ceiling – is strong enough to hold 4 times GEO S12 EN54 weight and that
the fou
r screws 12mm diameter and corresponding plugs required to fix the “U” bracket on the wall or
under the ceiling are properly dimensioned.
Procedure
- Remove the four TORX screws holding connector plates on both sides of GEO S12 EN54
- Position the GEO S12 EN54
inside the “U” Bracket to desired angle; “U” bracket oblong holes must be properly aligned
with panels holes
- Apply Loctite 243 or equivalent to the eight screws and washers from VNI-UBRK12 kit
- Connect
“U” bracket to cabinet with these screws
- Four
screws 12mm diameter (not provided) are required to secure the “U” Bracket on the wall or ceiling