10
FORM NO. L-20255-H-0822
5H-SE, FLANGE MOUNT (continued)
REFER TO FIGURES 4 & 5.
11. Apply an adequate amount of Loctite® 680 to evenly
coat the outer races of the new Ball Bearings (Items 8
and 9); then, press the new Ball Bearing (Item 8) into
the Cylinder (Item 2) and the new Ball Bearing (Item
9) into the Spring Housing (Item 20).
12. Apply a thin coat of O-ring Lubricant to the O-ring
contact surfaces of the Piston (Item 3), Cylinder (Item
2), and the new O-ring Seals (Items 12 & 13).
13. Install the new O-ring Seal (Item 13) into the Cylinder
(Item 2) and the new O-ring Seal (Item 12) onto the
Piston (Item 3).
14. Making sure not to damage the new O-rings Seals
(Items 12 and 13), press the Piston (Item 3) into the
Cylinder (Item 2).
15. Press the Drive Ring (Item 4) into the new Ball Bearing
(Item 8) and Cylinder (Item 2).
16. Install Die Springs (Item 22) into the Spring Housing
(Item 20) sockets.
17. Position the Spring Housing over the Cylinder/Piston
assembly, align the clearance holes with the tapped
holes in the Cylinder.
18 Insert Cap Screws (Item 23) into the Spring Housing
and tighten alternately and evenly until the Spring
Housing is flush with the Cylinder. Torque the Cap
Screws to the values shown in Table 3.
19. Remove the Retaining Ring (Item 11).
20. Press Hub (Item 1) out of the Drive Flange (Item 5).
NOTE
Do not remove the Backing Plate (Item 6)
from the Hub (Item 1).
21. Remove the Retaining Ring (Item 10) from the Drive
Flange (Item 5).
22. Press the old Ball Bearing (Item 9) out of the Drive
Flange (Item 5).
23. Clean the bearing bore of the Drive Flange (Item 5)
with fresh safety solvent, making sure all old Loctite®
residue is removed.
24. Apply an adequate amount of Loctite® 680 to evenly
coat the outer race of the new Ball Bearing (Item 9);
then, press the new Ball Bearing (Item 9) into the Drive
Flange (Item 5).
25. Apply a thin coat of Never-Seez® to the teeth of the
Drive Ring (Item 4).
26. Press the Drive Flange (Item 5) and Hub (Item 1) into
the Cylinder (Item 2) and Drive Ring (Item 4).
27 Reinstall the Retaining Ring (Item 11).
28. Reinstall the Retaining Ring (Item 10).
29. Press the Hub (Item 1) into the Drive Flange (Item 5) and
new Ball Bearing (Item 9); then, reinstall the Retaining
Ring (Item 11).
FIGURE 4
11
10
9
5
1
Do not remove
Backing Plate
(Item 6).
FIGURE 5
Apply a thin coat
of Never-Seez®
5
1
4
11
2
Model
Tightening Torque
5H30SE
5 ft-lbs
5H35SE
5 ft-lbs
5H50SE
6 ft-lbs
TABLE 3
