Nexcom PEAK 6320A, User Manual

Page: 63 / 91

PEAK 6320A User’s Guide
BIOS Setup 4-
32
4 provide successively increased performance. In Auto mode, the system
automatically determines the best mode for each device.
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and
the operating environment includes a DMA driver (Windows 95 OSR2 or a third-party
IDE bus master driver). If your hard drive and your system software both support Ultra
DMA/33, select Auto to enable BIOS support. The Choice: Auto
(Default) , Disabled
On-Chip Primary/Secondary PCI IDE
The integrated peripheral controller contains an IDE interface with support for two IDE
channels. Select Enabled
(Default)
to activate each channel separately.
Onboard PCI SCSI Chip
This item allows you to determine whether onboard PCI SCSI chip is enabled
(Default)
or not.
USB Keyboard Support
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you
have a USB keyboard. The Choice: Enabled, Disabled
(Default) .
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system
board and you wish to use it. If you install and-in FDC or the system has no floppy
drive, select Disabled in this field. Choices: Enabled
(Default)
, Disabled.
Onboard Serial Port 1/Port 2
This item allows you to determine access onboard serial port 1/port 2 controller with
which I/O address. The Choice: 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled,
Auto
(Default)
.
UART 2 Mode
This item allows you to determine which Infra Red (IR) function of onboard I/O chip.
The Choice: Standard
(Default) , IrDA1.0, ASK-IR, IrDA1.1