NIO200 HAG User Guide
Page 53 of 120
burst message, the update period and maximum update period in 1/32 ms not exceed 3600s
as configured through command 103,
2. Click
Save
. The burst message definition will be added to the list and the changes will be
saved in the Monitoring Host configuration file,
3. Add the variables to be published, by following the steps described under 7.3.5.2 Variables,
4. Add the burst trigger, by following the steps described under 7.3.5.3 Triggers.
You can also add a burst message based on an existing one:
1. Click on a burst message in the list,
2. In the edit box, change the EUI64 and burst message index into that of the new burst
message,
3. Change other parameters, if applicable,
4. Click
Save
. The burst message will be added to the list; the variables and triggers of the
original burst message are preserved in the newly added burst message.
To edit a burst message:
1. In the burst message list, click on the entry that you want to edit,
2. Edit the desired parameters and click
Save
. The changes will be stored in the
Monitor_Host_Publishers.conf” file.
To delete a burst message:
1. Select a burst message in the list and click
Delete
,
2. You will be asked for confirmation. Click
Yes
to delete the burst message or
Cancel
to abort
the action.
After you perform any of the above operations, click
Activate
to load the changes into the Monitoring
Host.
7.6.2. Variables
Summary of Contents for NIO200 HAG
