Copyright © 2019 NEXCOM International Co., Ltd. All Rights Reserved.
26
ICES 675 User Manual
Chapter 3: BIOS Setup
USB transfer time-out
The time-out value for control, bulk, and Interrupt transfers.
Device reset time-out
Selects the USB mass storage device’s start unit command timeout.
Device power-up delay
Maximum time the value will take before it properly reports itself to the Host
Controller. “Auto” uses default value: for a Root port it is 100 ms, for a Hub
port the delay is taken from Hub descriptor.
Network Stack Configuration
This section is used to configure the network stack settings.
Advanced
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enable/Disable UEFI Network
Stack
Network Stack
Ipv4 PXE Support
Ipv4 HTTP Support
Ipv6 PXE Support
Ipv6 HTTP Support
IP6 Configuration Policy
PXE boot wait time
Media detect count
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Automatic]
0
1
Network Stack
Enables or disables UEFI network stack.
Ipv4 PXE Support
Enables or disables IPv4 PXE support. If disabled, the IPv4 boot option will
not be created.
Ipv4 HTTP Support
Enables or disables IPv4 HTTP support.
