13- Control horn /
Control horn
......................2
2x30mm screw
................4
6x45mm nylon bolt
......1
! Securely glue together. If coming off during
flight, you lose control of your air plane.
Apply a thin layer of machine oil or petroleum jelly to only the pivot point of the hinges
on the elevator, then push the elevator and its hinges into the hinge slots in the
trailing edge of the horizontal stabilizer. There should be a minimal hinge gap and
the end of the elevator should not rub against the horizontal stabilizer.
When satisfied with the and alignment, hinge the elevator to the horizontal stabilizer
using 5 minute epoxy. Make sure to apply a thin layer of epoxy to the top and bottom
of both hinges and to inside the hinge slots. Repeat the previous procedures to hinge
the second elevator to the other side of the horizontal stabilizer.
Hinge
Petroleum jelly
STABILIZER
5 minute epoxy
Linkages
Anlenkungen
Elevator push rod (Right)
Tail gear push rod (x2)
FIN
RUDDER
ELV. (R)
ELV. (L)
RUDD.
To Elevator control horn (Left)
Rudder push rod
Elevator push rod exit
TOP VIEW /
Draufsicht
SIDE-VIEW /
Seitenansicht
A B
12- Elevator / Hohenruder
