Use a small glue faucet, Apply the thin CA glue on
the horizontal stabilizer where it contacts the fuselage
(both the top and bottom sides),and into the slot of the
fuselage as show.
Step 10:1
When you are satisfied with the alignment,
use a pencil to trace around the top and bottom
of the horizontal stabilizer where the horizontal stabilizer
meet the fuselage.
Trial fit the horizontal stabilizer in place .
Be cautious
not to cut into the wood
,
this will weaken the structure
.
Cut away only the covering both
the right and left side
A = A’
B = B’
A
A’
90
O
90
O
B
B’
Cut away only the
covering both the
top and bottom sides.
CA
Thin CA glue
When you insert the horizontal stabilizer into
the slot on the fuselage, if necessary, use
sander to widen the slot to make this easier.
Remove the horizontal stabilizer from the fuselage.
Using the sharp hobby knife, carefully cut away the
covering
inside
the lines
which were marked above.
Securely glue together. If coming off during flight,
you lose control of your air plane.
P-51 Voodoo
10- Horizontal stabilizer
Step 10:2
Step 10:3
Step 10:4
