Cut away only the
film on both side*
A = A’
B = B’
C = C’
B
B’
C
C’
A
A’
90
O
90
O
6- Horizontal stabilizer
Cut away only the
covering on both sides
Trial fit the horizontal stabilizer in place. Check the alignment
of the horizontal stabilizer.
If the parts will join, but with a gaps, sand the stabilizer slot on
the fuselage a little at a time until the parts meet exactly with
no gaps.
Remove the horizontal stabilizer from the fuselage.
Using the sharp hobby knife, carefully cut away the
covering
inside the lines
which were marked above.
When you are satisfied with the alignment,
use a pencil to trace around the top and
bottom of the stabilizer where it meets the
fuselage.
