Note: Cut out the stickers and apply them in the proper area. Do not peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors. Arrange sticker on model and when satisfied adhere the
corner without backing.
Carefully peel back the rest of the backing while at the same time adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully puncture sticker (center of bubble) but not model surface
with the tip of the knife or sharp pin and squeeze out the air. At curves stretch sticker and apply a little heat so that no
ceases occur. Cut off the excess that is produced.
CHINESE AIR-FORCE (AVG)
VQA022C
P428
16- Decal
1-23/64”(35 mm)
15/64”(
6mm
)
13/32”(10mm)
RUDDER STROKE
ELEVATOR STROKE
AILERON STROKE
Adjust the travel of the control surfaces to achieve the values stated in the diagrams.
These value will be suitable for average flight requirements. Adjust the values to suit your particular needs.
Wing center section
DO NOT try to fly an out-of-balance model !
4”~4-1/8”
(100~105mm)
Note: If necessary, move the battery pack or add weight to either the tail
or nose until the correct balance is achieved.
15/64”(
6mm
)
13/32”(10mm)
1-23/64”(35 mm)
51/64” - 1-3/16”
(20 - 30mm)
FLAP
All details are subject to change
without notice !
Technische Anderungen und Irrtumer
vorbehalten !
IMPORTANT:
Please do not clean your model with pure alcohol or strong solvent, only use liquid soap with water or
use glass cleaner to clean on surface of your model to keep the colour not fade.
17- Balance
18- Control surface
