Newtons4th PSM3750 NumetriQ, Startup Manual, Page: 48 / 104

PSM3750 Quick User Guide
Page 46
Within the “OUTPUT” mode set the
amplitude parameter to the peak
voltage signal required from the
instruments generator. Frequency
can be set to display the on screen
measurements
at this stated
frequency, once all parameters are
set then change
the “output” to ON .
Within the CH1 /CH2 menu set the
coupling to ac only as described in an
earlier section called “FRA Sweep
with ac Coupling”. Pressing will
take you directly to the CH2 display.
Channel 3 ranging is accessed from
within Ch2 mode by using the
arrow.
Upon pressing the “START” button the Frequency Sweep will commence and the
measurements can be viewed in; Real time, Table or Graph mode.
Gain, Phase and Delay measurements at each frequency point are displayed.