56
Connecting with Master and Slave Systems
Connect First with the Master Control Unit
Connect
establishes communication between the UI application and the T-DAR
hardware. A connection must be established with the master before connections can
be made with the slave units. Ensure you have the proper master/slave user
interface that was shipped with this T-DAR system. Connect with the master control
unit as described on the previous page.
Connect with Slave Control Units
Once a connection is established with the master control unit (Connected is
displayed on the status bar), connecting with the individual slave unit/s should now
be performed.
Figure 22a
– Slave Connection
To establish a slave
connection, open the first “Slave” tab (shown in figure 22a) and
enter in the IP address of any four head slave unit (the IP address is on the door of
the control unit). If there is only one T-DAR slave and it is a two head unit, use the
“Slave” tab. There is only one slave tab on a single slave T-DAR system. Click
“Connect” to establish communication between this slave unit and the master control
unit. If there are multiple four head slave units, connect these using the 2
nd
and 3
rd
“Slave” tabs, leaving the rightmost “Slave” tab for the two head slave connection.
Summary of Contents for T-DAR T1010MT
