Newton T-DAR T1010MT, Installation And Operation Manual, Page: 50 / 112

43
Door Position Sensor (Door Encoder)
A public Inward Swinging door must use an I100 Door Position Indicator. If an I100
Door Position Indicator is not used for public doors that swing into the field of view of
the camera, erratic operation will result. The secure door does not require the use of
a Door Position Indicator. The cable for connecting the sensor should be extended
from the wall/frame and terminated into the unit. The cable is a straight through
Ethernet (cat 5) cable terminated with an RJ-45 connector. The other end of the
cable is then terminated as flying leads on the D portal connector as shown below.
Up to two door encoders can be installed on a single mantrap. When using a second
door encoder, terminate the leads on the portal C connector. In master/slave T-DAR
systems, wire door encoders to master control units only.
Public Door Encoder Connection
Annunciator Unit
The annunciator unit should be located at the security portal being monitored so that
violations are immediately announced to the violator as well as persons in the
secure area. The annunciator unit should be mounted less than 30m (100ft) from the
control unit. Install and terminate one Ethernet cable (straight through) on the
Annunciator Unit, leading directly to the ‘Annunc 1’ connector on the T-DAR control
unit. T-DAR mantraps use one annunciator. A master/slave T-DAR system will
require the annunciator be plugged into the master control unit. If the annunciator is
not turning on or is not playing the proper recordings, use the test buttons on the
“Advanced” tab to test the functionality. If the strobe and/or voices do not play using
the test buttons, check the CAT5 cable using a network tester (unplug cable before
testing). Warning: plugging in a camera head (CAT5 cable) into an annunciator port
will damage the camera head.