M74050
1/4M IMAGING SPECTROGRAPHS
7
1.2 GENERAL WARNINGS
•
Read all warnings and operating instructions for this system prior to setup and use.
•
Do not use this equipment in or near water.
•
To prevent damage to the equipment, read the instructions in the equipment manual for proper
input voltage and check the requirement on the power supply.
•
This equipment is grounded through the grounding conductor of the power cord.
•
Route power cords and other cables so they are not likely to be damaged.
•
Disconnect power before cleaning the equipment
•
Do not use liquid or aerosol cleaners; use only a damp lint-free cloth.
•
Lock out all electrical power sources before servicing the equipment.
•
To avoid explosion, do not operate this equipment in an explosive atmosphere.
•
Qualified service personnel should perform safety checks after any service.
•
If this equipment is used in a manner not specified in this manual, the protection provided by this
equipment may be impaired.
•
Do not position this product in such a manner that would make it difficult to disconnect the power
cords.
•
Use only the specified replacement parts.
•
Follow precautions for static sensitive devices when handling this equipment.
•
This product should only be powered as described in the manual.
•
Do not remove the cover for normal usage.
1.3 ELECTRICAL HAZARDS
Make all connections to or from the instrument with the power off.
This instrument requires DC voltage for operation, which is provided by an external power supply.
This power supply has no user serviceable parts. Do not attempt to open the external power supply.
Do not attempt to work in the instrument compartment without first disconnecting the power cord,
since electrical hazards are present inside the compartment
even with the power switch in the “off”
position.
The MS260i contains a microprocessor and should be installed with appropriate surge/EMI/RFI
protection on the power line. A dedicated power line or line isolation may be required for some
extremely noisy sites. The electronic circuits within the spectrograph are extremely sensitive to static
electricity and radiated electromagnetic fields. Operation of this instrument close to intense pulsed
sources (lasers, xenon strobes, arc lamps, etc.) may compromise performance if shielding is
inadequate, and may cause permanent damage to the microprocessor.
Note: This instrument conforms to CE standards for both safety and EMC. During normal use, this
equipment will not pose any electrical hazards to the user. Read all warnings before installing or
operating this system. If there are any questions or concerns, contact Oriel Instruments or the
regional sales representative for Newport.