11
Add oil and check oil level
6)
Fill the tank with oil until the level is aligned with the red OIL
mark on the sign next to the sight glass.
7)
Refit the rubber plug to the oil pipe to cover the port opening.
8)
Refit the air intake filter if removed while filling with oil
WARNING
To prevent serious injury from burns, do not add or change the
oil while the compressor is in operation.
CAUTION
Use ROLOIL-SINCOM/32E oil with ACGP compressors. Using
other types of oil will void the warranty and likely damage the
unit.
2.5
Operation
2.5.1
Turn on/off air compressor
Make sure that the power supply voltage is the same with what’s indicated on
the data label: 230V/50 Hz or 115V/60 Hz. Use only 3-pole receptacles that
accept the compressor’s plug.
The on/off switch is located on the top of the pressure switch (see Figure 5).
To switch the unit on, turn the switch to position “1”. When switched on, the
compressor starts to build up pressure until the tank reaches the maximum
allowed pressure (8 bar/120 psi). The unit will then be automatically
switched off until air is used and the pressure in the tank drops to the
minimum operating pressure (6 bar/90 psi), at which point the compressor
automatically switches on.
