(9)
PROPERTY
RED AND GREEN LIGHTS
ADJUSTING THE THERMOSTAT
Factory temperature pre-set
is 190°F
+
-
(88°C) ±5°. To reset the
thermostat to that setting, turn
the indicator two notches
to the right of vertical.
MIN
MAX
Adjust the thermostat
approx. 194°
slowly, turning the dial
clockwise to increase temperature or
counter clockwise to decrease
temperature, then activate water
dispenser handle for 20 seconds to
bring in fresh water to be heated at the
new setting. Allow 5-7 minutes for
water to reach new temperature.
Scalding Hazard: Do not allow
water to boil. May result in
severe burns.
Poor water flow:
• The tank is not under pressure
which may cause a slight delay
in water flow. This is a safety
feature.
• Make sure all valves on water supply are open.
• Check hose from water dispenser for twisting or tight bending.
• Check if quick-connect filter screen or water dispenser filter screen is clogged
(see water dispenser manual). Clean if necessary.
Water boils or
vapor appears:
• The thermostat may be set too
high.
• Lower temperature setting by turning thermostat control counterclockwise.
Hot water drips or
sputters from
faucet:
• The thermostat may be set too
high.
• Turn the thermostat control dial counterclockwise to reduce the temperature.
• Ensure that the hose connecting the water dispenser to the hot tank is not
clogged, twisted or kinked.
• Check for a clogged filter screen in the quick-connect fitting (see
CLEANING THE QUICK CONNECT FILTER SCREEN instructions
above).
• Check for proper installation of tubing from water dispenser to hot water
tank and water dispenser to water line. If connected backwards or cross-
connected, valve may be damaged.
Electric Shock Hazard: To prevent electrical shock, disconnect power before
servicing unit. Use only a properly grounded and polarized electric outlet.
Regularly
inspect the unit for any signs of leakage. If
there are signs of water damage, immediately remove
the unit from service.
To avoid water damage from leakage, replace all cut,
loose or split tubing.
A drain
pan, plumbed to an appropriate drain or
outfitted with a leak detector, should be used in those
applications where any leakage could cause property
damage.
The Green light indicates
hot water is
available.
The Red Light indicates water is heating in
the tank.
Only use mild cleaners to clean the water
dispenser and plastic components.
Cleaners with acids, abrasives, alkaline or
organic solvents will
result in deterioration of the
plastic
components and void the warranty.
CLEANING THE WATER DISPENSER AND TANK
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE WHAT TO DO
CARE AND USE