Newport Brass 5-036 Installation & Operating Manual Download Page 4

(4)

 

 

SAFETY INSTRUCTIONS | Please Read All Instructions Carefully

 

 

 

Electric Shock Hazard: 

Using an ungrounded or improperly connected appliance can result in serious injury or 

death from electrical shock.

 

 

This appliance must be grounded. 

This instant hot water tank is equipped with a cord that has a grounding 

conductor and a grounding pin. The plug must be connected to an appropriate outlet that is properly installed 
and grounded in accordance with all local codes and ordinances. Do not modify the plug provided with the 
appliance – if it will not fit the outlet, have a proper outlet installed by a qualified electrician. Check with a 
qualified electrician or serviceman if you are in doubt as to whether the hot water dispenser is properly 
grounded.

 

 

Personal Injury: 

This tank is a non-pressurized tank. DO NOT modify this system. DO NOT close vent tube or 

connect other brand dispensers or valves to the tank. Use only with a Newport Brass brand hot water dispenser 
faucet. Use only parts provided. Contact a certified repair person for repairs or replacement components.

 

 

Fire Hazard: 

To minimize the possibility of fire, DO NOT store flammable items such as rags, paper or aerosol

 

cans near the tank. DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or

 

any other appliance.

 

 

 

Property Damage: 

To avoid water damage, replace any loose or split tubing. Periodically inspect the unit for 

any signs of leakage and immediately remove from service any unit suspected of leaking.

 

 

When using electrical appliances, basic safety precautions should always be followed: 

 

1. Do not attempt to service this product. Repairs should be done by authorized service personnel.

 

 

 

2. Do not operate any appliance with a damaged cord, plug, or after the appliance malfunctions.

 

 

 

3. Do not use outdoors or in a damp area.

 

 

 

4. Do not let the cord hang over the edge of a table or counter, or touch hot surfaces.

 

 

 

5. Do not use appliance for other than intended household use.

 

 

 

6. When using the appliance, provide 4 to 6 inches of air space around the entire unit for air circulation.

 

 

 

7. To protect against electrical shock, do not place cord, plugs or the appliance in water or other liquid.

 

 

 

8. Do not let children operate. Hot water can cause severe burns.

 

 

 

9. The appliance must not be immersed.

 

 

 

SAVE THESE INSTRUCTIONS.

 

THIS PRODUCT IS FOR HOUSEHOLD USE ONLY.

 

The alert symbols displayed at the right point to important safety information to make 
you aware of potential hazards that can cause serious injury or death. Please pay 
special attention to the information following these alerts and warnings. Failure to 
comply with these instructions can result in property damage, serious injury or death.

 

Summary of Contents for 5-036











Reviews: