There are two motors, and both trantorque bushings will need to be loosened.
Now the room can be pushed in manually with
the assistance of
four to six people, as the
Full Wall Slideout
will need to
be
pushed up the ramp onto
the floor.
After the Slideout has been pushed in, tighten the trantorque
bushing
to 175 FT
Lbs.
Manual Retraction - Method 2
© 2016 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
Follow the steps to manually retract the Slideout
using the
gear reduction nuts.
First, locate the strap that secures the rubber boot on the
outside of the motor. Remove the strap, and pull off the
rubber boot, removing it from the motor.
Remove the four screws from under the rubber boot on the
brake.
Once the brake is removed, use a screw gun or a ratchet
with a 5/8" socket to turn the gear reduction nut to retract
the
Slideout.
Screw guns are recommended due to the major reduction in the gears. It will take many revolutions of the gear
reduction nut to retract the Slideout.
After the Slideout is fully retracted, reinstall the brake.
