Page 1
Raymor Showers / Pivot Door Set
SLIDING DOOR SET / Important Information
IMPORTANT
When you receive your Raymor shower check contents for any freight damage. Advise
Newline on 0508 639 5463 if any damage has occurred within 8 hours of receiving the
goods so this is can rectified. Do not proceed with installation until resolved.
WARRANTY
Faulty goods are covered under warranty. Visit www.newline.co.nz for warranty information.
Breakages incurred during installation are not covered under warranty.
HEALTH AND SAFETY
Toughened Glass:
• Do not rework precut glass panels. Cutting or altering a glass panel will cause it to
explode without warning.
• Unpack all glass assemblies. Stand glass on soft packaging when it is on the floor
and against a wall. Care must be taken not to strike any edge or corner against a hard
surface as this will chip and destroy the glass panel.
Installation:
• Glass panels and assemblies are heavy. Two man lifting is recommended for handling
and installation.
• Determine positioning of wiring and piping within wall cavities before shower installation.
Mark their positions to ensure electrical and piping areas are avoided.
• Wear appropriate protective clothing and eye protection during installation.
TOOLS REQUIRED
Spirit Level
Soft pencil
Masking Tape
Electric Drill and Bits
Tape measure
Square headed Screwdrivers
Cleaning Materials and Rags
MATERIALS REQUIRED
Sika Silaflex NG translucent Silicone.
AFTERCARE
The shower must be thoroughly cleaned weekly with a microfiber cloth, mild detergent and
water. Rinse with clean water and squeegee and wipe dry. Note: Glass panels are factory
pretreated with EnduroShield glass coating protection. Please visit enduroshield.com to
register your warranty and view cleaning and warranty requirements.
INSTALLATION
It is recommended that a professional shower installer is used to install this product.
