Page 9
Raymor Showers / Pivot Door Set
15mm
INSIDE OF SHOWER
INSTALLATION STEPS / Alcove
Configuration
STEP 1
1. Mark out the Wall Channels up the wall as indicated to establish the outside boundary
line.
2. Take one Wall Channel only, apply silicone to the back and fasten to the wall. Note:
Flange to the inside.
Tiling Note: Some authorities do not allow the waterproof layer to be penetrated. Use
Bostik V60 to fix Wall Channels and allow to cure as per manufacturers instructions.
STEP 2
Assembly of Door Frame
Components: -Top and bottom rails (13) Fixed front panel (14) Corner post (17) Spacer
Blocks (6) 4 x 35mm screws (3) Two spacer Blocks( 6) Two Glass clamps (16) and
2 screws 4x10mm Note: Refer back to Assembly Drawing on page XX to reference
numbers.
1. Assembly: - Bring the Door Frame together as illustrated and with the 35mm screws
and glass clamps secure the frame.
2. Check the frame is square and tighten all fastenings
