Newland HR1550-30 Wahoo, User Manual

Page: 46 / 216

**
【
Enter Setup
】
【
Exit Setup
】
34
Hands-free Scanning (Hardware Version: V1.3 or higher)
Inserting the scanner in the stand enables the scanner to switch from its current scan mode to the Sense mode. The red
LED on the scanner illuminates to indicate that the Sense mode is enabled. And the scanner is ready for hands-free
scanning. When the scanner is removed from the stand, it operates in its previous scan mode. The red LED extinguishes.
Manual-Sense Mode Switch (Hardware Version: V1.3 or higher)
If the Manual-Sense Mode Switch is enabled, holding down the trigger for a certain period of time (decode session timeout
+ wait time) can switch the scanner currently in the Manual mode to the Sense mode. The scanner beeps to indicate that
the Sense mode is enabled. To revert back to the Manual mode, simply press the trigger.
Scan the appropriate barcode below to enable or disable this feature.
**
【
Disable Manual-Sense Mode Switch
】
【
Enable Manual-Sense Mode Switch
】
Trigger-press duration is the sum of decode session timeout and wait time.
For the details about decode session timeout, refer to the
“
Manual Mode
” section in Chapter 2.
Wait Time: 00-07, corresponding to 0-7s, in 1s increments. Default: 3s
【
Wait Time
】
Example: Set the wait time to 5s
1. Scan the Enter Setup barcode.
2. Scan the Wait Time barcode.
3. Scan the numeric barcodes
“
0
”
and
“
5
”
. (See the
“
Digit Barcodes
”
section in Appendix)
4. Scan the Exit Setup barcode.