Newland HR1550-30 Wahoo, User Manual, Page: 45 / 216

**
【
Enter Setup
】
33
【
Exit Setup
】
Command Trigger Mode
Command Trigger Mode: The scanner activates a decode session when receiving the command string of
“
$$$$#99900035;%%%%
” or scanning the
Start Trigger Simulation barcode. The decode session continues until the
barcode is decoded, or the scanner receives the command string of
“
$$$$#99900036;%%%%
” or scans the
Stop Trigger
Simulation barcode.
If the scanner receives the command string of
“
$$$$#99900036;%%%%
” or scans the
Stop Trigger Simulation barcode
during a decode session, it will stop the decode session and send a 2-character message (e.g., 0A or 0X ) to the host
device to indicate decoding failure.
【
Command Trigger Mode
】
【
Start Trigger Simulation
】
【
Stop Trigger Simulation
】
You can define a no read message to be sent to the host device when the scanner in the Command Trigger mode fails to
decode a barcode.
【
Define a No Read Message
】