Attach the Front
Support/Center
Frame assembly to
one end of the table.
Connect Front Support
Plate (#7) to Robot
Center Frame (#6); one
side of the pivot tube
in the Front Support Plate will
mount to the pivot pin on the
front of the Robot Center
Frame and an Allen Bolt will
secure the other side.
ASSEMBLY/USE INSTRUCTIONS
VERIFY ALL PARTS
Cover your table tennis table top with either
a towel or other soft cloth for protection.
Unpack all the parts from the box and lay
them out so you can identify them. Become familiar
with each part as shown in this diagram. If uncertain
of the identity of a part, look for a small silver tag
with the name of that part.
1. Collection Trays (1 Left/1 Right)
2. Curved Net Support Tube, Long (1 piece)
3. Curved Net Support Tube, Short (2 pieces)
4. Hardware Packet (3 Allen Head Bolts, Allen Head
Wrench, 1-Winged Head Thumb Screw)
5. Main Net (1 Piece)
6. Center Frame and Net Bag (1 Piece)
7. Front Support Mechanism (1 Set)
8. Side Net Clip in Small Plastic Bag (2 pieces)
The Newgy Versa-Net is a multi-function net system
to enhance your playing experience. Use it with
your Robo-Pong 540(+)/1040(+)/1050(+)/1055
to recycle balls, as well as work as a catch and
collection net for multi-ball and serve practice.
With the Versa-Net, now you can play and practice
longer; reduce the need to stop and pick up balls as
often!
ASSEMBLY STEPS
Please read each step in its entirety. Then perform
each step point by point. Pay close attention to the
directions, especially the italicized words. Refer often
to the diagrams of Step 1 for part identification.
Connect the
Collection Trays (#1)
to the Center Frame
assembly; place the
smooth edge toward the
table and insert the frame
onto the pivot pin at the front
of the Center Frame
assembly and use an Allen Head Bolt to secure the
other side.
Repeat the above steps for the other tray.
1
2
4
5
6
7
8
3
1
2
3
4
5
ERSA
V
ERSA
ERSA
V
V
ET
N
ET
ET
N
N
N
EWGY
™
Insert the Long, Curved
Net Support Tube into
the slot at the rear of
the Center Frame
assembly and use the Winged
Head Thumb Screw to secure
the Tube.
6
