Newgrind RHINO RLP800, User Manual

Page: 12 / 22

RLP800 Users Manual
12
5. Hold the replacement tool up against the desired slot on the tool plate and
insert/tighten the bolt.
NOTE: Rhino tool plates have spaces for up to 6 tools. Using 3 evenly spaced tools per plate is
standard configuration.
6. Inspect the grommets to make sure they are not worn or missing
7. Re-attach the tool plate by pushing it back into place
8. Hold the plate firmly with both hands and jiggle it to make sure its properly attached
9. Repeat with each of the tool plates
WARNING: only use tools that have been designed for the machine, and make sure that
the same type of tool is being used on all plates/positions.
10. Gently tilt machine back to upright position by lifting the handle
11. Follow the procedure for starting the grinder
Parts and accessories
A full range of parts and accessories for all of our grinders is available on our website.
Grinder Maintenance
WARNING: Disconnect power before performing any maintenance, cleaning, or repair to
your equipment!
General Maintenance

When the equipment is not in use, make sure that the adapter plate assemblies have
something attached to them to protect the Velcro. Resting the machine directly on
unprotected Velcro will crush the fastening material causing the Velcro to become unusable.
Daily Maintenance

Wipe down the equipment after every job.

Gently remove dirt and debris from the Velcro hook material using a wire brush. This will
ensure maximum adhesion.

Check that the handle bolts are tight.

Vacuum or wipe underside of machine.

Check all fasteners and tighten if necessary.
Weekly Maintenance

Inspect handle wires for damage.