Package Contents:
• Newer Technology miniStack v2 Enclosure
• External Power adapter
Input 100-240V, 12V/2A, +5V/2A
Hard Drive Screws
• Power Cord
• USB 2.0 A-B Interconnect Cable (15”)
• 1394A 6-6 Interconnect Cable (15”
)
Hard Drive Installation:
1.
Begin by removing the 4 Phillips screws from the bottom
of the Newer Technology miniStack v2 enclosure. Remove the
drive carrier from inside of the Newer Technology miniStack v2
enclosure.
Please observe all static safe
precautions before proceeding.
Discharge any excess static
electicity safely before
removing any electronic
component from it’s protective
anti-static bag.
4
2.
Make certain that the hard drive mechanism you’re installing
inside the Newer Technology miniStack v2 enclosure is set to
MASTER before installing. You can find this information either
on the drive mechanism, or by visiting the drive manufacturer’s
website.
Place the ATA drive onto the mounting bracket as shown. The
connecting cables need to be positioned to the left, with the
opening in the drive bracket to the top. Once inserted properly
into the bracket, insert the 4 included screws to fasten it securely.
3.
Place the drive and bracket inside the Newer Technology
miniStack v2 enclosure, routing the power and ATA cables to
avoid pinching them. The ATA cable will need to be folded at a 45
degree angle once it’s set into the drive enclosure.
Take the black and white wire at the bottom left of the enclosure
in this picture and tape the thermal probe (the blue portion of
the wire) onto the center of the hard drive using the enclosed
piece of tape. Once the drive is inserted, replace the 4 Phillips
screws on the bottom of the enclosure to fully secure the drive
carrier. Make sure that all wires are as flat as possible and place
the plastic top back onto the drive enclosure. Be sure before
continuing that there are no bulges in the top cover.
5
