Using a retractable pen (a flat tool that you can push with, and not cut the cable is all that’s required), gently push
on each side of the dock connector to release it from the dock cable slot. Once you press it out of the slot, the pen
will slide into the GripStand Station housing.
Once you have released the dock cable from the GripStand
Station, remove it from the black wire loom that is used for
cable managment. Then, slide the cable out from the inside
and remove it completely.
Take your replacement cable and feed it back through the
hole that you removed the cable from.
Make certain that the iPad is laying flat in the GripStand Station side guide rails and then firmly push in on the iPad,
pressing the dock cable into the back wall of the GripStand Station. This seats the dock cable perfectly flat and
straight into the retaining slot for the dock connector. Reinstall the cable into the guide channel and replace the
plastic cable cover and the replace the black wire loom around the USB cables to complete the installation.
Copyright ®2011-12 Newer Technology Inc. All Rights Reserved.
NWTMANGSSCBL
R2 12/20/11 JD
⑤
⑥
⑦
⑧
⑨
⑩
⑪
Insert the new 30-pin dock cable into the iPad. Remember, the iPad is up-
side down so the Newer Technology logo on the dock cable will be facing
away from you when you plug it in.
Slide the iPad into the slot where the cable has been removed from. Gently
feed the cable into the hole in the back of the GripStand Station, being very
careful to not pull on the cable too much; you do not want to disconnect it
from the iPad. Feed the cable all the way back through the hole. When you
feel resistance, meaning the dock cable is against the back wall, STOP.
