7
6. Remove the 3 screws on the left side of the
service opening that secures the locking cover
assembly.
*See Figure 10
7. Remove the locking cover assembly by lifting it
vertically.
*See Figure 11
8. Grasp the back-up slide arm (gray color) and
push up until the lock member arm (gray color)
can be separated from the back-up connect
blocks (gray color).
*See Figure 12
9. Remove the 4 screws on the left side and the 5
screws on the right side of the control heart
assembly.
*See Figure 13
10. Push in at the bottom of the right side of the
control heart assembly and snap the control
assembly off the back cover.
11. To remove the back cover, remove the screw
located below the coin box support at the top of
the steel tube. Remove the 2 screws at the
bottom left side of the back cover and rotate the
back cover counter-clockwise until the tabs
along the bottom perimeter of the cover are
clear of the tabs on the base.
*See Figure 14
12. Grasp the back cover on the top with the right
hand and spread the lower left side of the cover
out with the left hand. Lift the back cover from
the base.
13. To remove the carousel, retract each detent
wheel (dark purple color) slightly and lift the
carousel enough above the detent wheel, so the
detent wheel can move under the carousel and
release the spring tension.
14. After both detent wheels are released under the
carousel, lift the carousel off the base. Remove
the thrust washer located on the steel tube under
the carousel.
Fig 10
Fig 11
Fig 12
Fig 13
Fig 14
