Newco B-10-T3, Operating Instructions Manual, Page: 26 / 29

26
Daily Sanitizing Instructions
1. Remove the product BIBs from the machine and connect a BIB of
sanitizing solution to the PUMP 1 BIB connector as shown in figs. 1-
4 pages 23-25
2. Enter “Programming Mode” by pressing and holding “Reset” button
3. Press the “Coffee Regular” button on the display panel to enter
‘Maintenance” Mode.
4. Display will change to “Install Sanitizing solution” “Press Decaf
Button to Start Sanitation Cycle”.
5. Place an empty 12 oz. cup in the dispense area then press the Decaf
Button to start the Sanitation Cycle. Cycle will start and finish
automatically.
6. When sanitizing cycle ends (2.5 minutes total: pump 45 sec., dwell 90
sec., & water 15 sec.), the buzzer alarm will sound 3 times if enabled
during the “Set-Up Programming”.
7. When sanitizing cycle ends, disconnect the BIB of sanitizing solution
from the Pump BIB connector and replace the coffee BIB product. The
machine will automatically advance to the Prime Pumps mode.
8. To Prime: Press and hold the “Decaf” button until a steady stream of
product flows from the dispense area into the vessel.
9. Press “Café Latte” (Upper right) Button to advance to Pump 2 Change
Sanitizer solution to Pump 2 and repeat steps 3-8 to clean and
Sanitize Pump 2.
10. Press and release the “Café Latte” Switch until “Exit Maintenance
Mode” appears on the display- Press “Coffee Regular” button to exit.
11. Press and release the “Café Latte” Switch until “Exit Programming
Mode” appears on the display- Press “Coffee Regular” button to exit
and return to normal Run mode.
12. Discard the Contents of the 12 oz cup