NJT8302 series Instruction Manual
Page 17
・
・
DO NOT remove the fim on the waveguide when the unit has it.
If the film is removed, it may lose the performance of
waterproof.
6.2.1. Connecting Coaxial Cable
The Unit is connected a coaxial cable and ground wire.
6.2. Connecting System
IM-T8302 Rev.01
Connecting the coaxial cable is proceeded with the following steps:
Step 1:
Connect the coaxial cable with the N or F-type male connectors
to the coaxial connecter equipped with the Unit which is shown
in a figure below under 0.68 to 1.13 N
・
m torque.
6.1.2. Guidelines for Mounting
When mounting on the the OMT or the filter, you should follow the
following cautions:
DO NOT block the fins.
Normally the Unit should be mounted with long fins face up.
The Unit receives an IF signal and a reference signal via coaxial cable from
modem, and is required to 15 to +30 V DC power via coaxial
cable from modem.
Supplied the IF/Ref./DC Power
via Coaxial Cable
DO NOT remove the fim
